Compression Fitting

Compression fittings for polyethylene (PE) pipe

Building an irrigation or water-supply network in PE pipe? The compression fitting clamps mechanically around the pipe, with no glue or welding: slide the pipe in, tighten the nut, and it is watertight. Simple, removable and reliable. Our experts help you find the right diameter.

Our range of compression fittings

• Equal couplers: to join two PE pipes of the same diameter.
• Elbows and tees: to branch or route your network at 90°.
• End caps: to close a PE pipe end cleanly.
• Wall plates and threaded fittings: to move from PE pipe to a threaded outlet.
• Reducers: to link two different PE pipe diameters.

Choosing the right compression fitting

• Measure the outside diameter of the PE pipe (20, 25, 32, 40, 50 mm...).
• Tightening is done by hand then with a wrench: no glue, no heat, no welding.
• Do not confuse it with push-fit waste PVC or solvent-weld pressure PVC.

The Piscine-SAV technical tip: push the pipe fully to the stop before tightening the nut for a perfect seal. If unsure, send us the reference.

Delivery across Europe and advice from our experts: build your PE network with complete confidence.