Wall fitting

Wall fitting: a watertight connection through your pool liner

The wall fitting is the sealed part that passes through the pool wall or liner to connect a hydraulic circuit. Skimmer, return inlet, vacuum point or light: it provides a clean, perfectly watertight link between the inside of the pool and the pipework. An essential part of the pool structure.

Our range of wall fittings

• Liner fittings : designed to be fitted on the liner of an above-ground or in-ground pool, with sealing gaskets.
• Various diameters : several bore sizes, including ø 30, to suit every hydraulic circuit.
• Vacuum point and return : to connect the manual vacuum suction or send filtered water back into the pool.
• Gaskets and nuts : the supplied flanges and seals ensure a watertight clamp against the wall.
• Skimmer compatibility : they complete the water circulation equipment of the pool.

Choosing the right wall fitting

• Diameter : check the bore diameter and that of the pipework to be connected for an exact match.
• Wall type : distinguish fitting on flexible liner, rigid wall or shell to choose the right gasket.
• Function : identify the exact use, return, suction or vacuum point, before selecting the part.

The Jardiboutique technical tip: always place the flat gasket on the liner side and hand-tighten the nut without tools so as not to pinch the membrane; this is the key to a lasting, leak-free seal.

Our wall fittings are selected for their tightness and resistance to water treatments, to keep your pool circuit reliable over the long term.