Compression tee 90° male thread

Compression tee 90° with male-threaded outlet

The 90° threaded compression tee creates a branch on your PE pipe with a male-threaded outlet. That threaded outlet screws directly into a female (tapped) part, such as a manifold or a valve. The two side ends clamp mechanically onto the polyethylene pipe, with no soldering.

Our range of threaded compression tees

• Male-threaded branch : the central outlet is threaded on the outside to screw into a tapped part.
• 90° angle : clean perpendicular branch to feed an accessory or a take-off.
• Clamps onto PE pipe : both side ports clamp onto the polyethylene, with no glue.
• Standard gas thread : standard BSP pitch for a reliable, watertight connection.

Choosing the right male-threaded tee

• Check that the part you connect to is female (tapped): the male thread of the tee screws into it.
• Check both the PE pipe diameter (side clamp) and the thread size (1/2", 3/4", 1"...).
• Need a female outlet that receives a male end? Choose our tapped compression tee instead.

The Piscine-SAV technical tip: male or female is exactly where mistakes happen: a male thread has the thread on the outside. If unsure, send us the reference and our experts will check the thread for you.

With the male-threaded compression tee you build a clean, removable branch without a torch. Our team helps you confirm the right diameter and thread before you buy.