Equal Compression Elbow 90°

Equal compression elbows 90° for PE pipe

Need to turn your polyethylene pipe at a right angle? The equal compression elbow 90° clamps mechanically onto two PE pipes of the same diameter, without glue or welding: slide the pipes in, tighten the nuts, and the angle is watertight and removable. Our experts help you choose the right diameter.

Our range of equal compression elbows

• 90° angle: to go around an obstacle or run neatly along a wall.
• Two identical outlets: same diameter on both elbow branches.
• Double clamping: a nut per side for reliable mechanical hold.
• All diameters: from Ø 20 to Ø 63 mm to suit your irrigation network.

Choosing the right equal compression elbow

• Measure the outside diameter of the PE pipe (identical on both sides).
• Cut each pipe square and deburr before insertion.
• Do not confuse it with a push-fit waste PVC elbow or a solvent-weld pressure elbow.

The Piscine-SAV technical tip: insert each pipe fully to the stop in the elbow before tightening the nuts. If unsure about the diameter, send us the reference.

Delivery across Europe and advice from our experts: route your PE pipe with complete confidence.