a 1 liter spa leak detector.

Used with all spa treatments

Easy and economical to use

Concentrated formula

Spa Leak Sealer is highly concentrated to seal small spa leaks from the shell or plumbing of acrylic or concrete spas and hot tubs.

Caution: Leak Sealer cannot be used if the water temperature is below 6°C.

DIRECTIONS FOR USE

1. Remove the filter cartridges or, for sand filters, select the BYPASS option before adding the product.

2. With the pump running, add the required amount of Spa Leak Sealer (see recommended dosage below) slowly into the skimmer (or other suction system).

3. Spa Leak Sealer is very heavy and will sink to the bottom. The pumps must be run regularly or even continuously to keep it in suspension

to keep it in suspension.

4. Let the water circulate for at least 3 hours. Then, check the state of the leak. If the leak is not completely repaired, continue

if the leak is not completely repaired, continue to operate the pump for an additional 3 hours.

5. When the leak is repaired, turn off the pump. The residue will settle to the bottom of the spa, and you can clean it up with a vacuum cleaner

and you can clean it up with a spa vacuum.

6. Replace the filters and allow the system to circulate for 45 minutes. Then, remove the filters and clean them thoroughly with water to remove any product residue.

7. It is recommended that the spa be drained and left empty for at least 48 hours to allow the product to dry and cure.

NOTE: If the leak is not completely sealed after the first application, which is possible, we recommend a second application

application.

DOSE

Pour 225 ml per 2,000 liters of water.